Epson PowerLite 480 Quick Setup - Page 2

Adjust the image 1 If you don't see an image, press the Source Search button on the projector or the remote control to select the image source. Note: If you still see a blank screen or have other display problems, see the troubleshooting tips on the back of this sheet. 2 To raise the image, press the foot release button and lift the front of the projector. Release the button to lock the foot in position. Using the remote control Make sure the batteries are installed as shown (two AA batteries). Turn projector on and off Choose which source to display 3 Press the Wide or Tele button to enlarge or reduce the image. Access projector menus Navigate projector menus 4 Raise or lower the focus lever to sharpen the image. 5 If your image looks like or , press the or buttons on the projector to correct it. 6 If your image looks like or , you've placed the projector off to one side of the screen at an angle. Place it directly in front of the center of the screen, facing the screen squarely. Or press the Wide or Tele buttons on the projector to correct it. Turn off projector display Get solutions to common problems For more information on using the remote control, see the online User's Guide. Project wirelessly Follow the steps here to connect the projector wirelessly over an 802.11g, 802.11b, or 802.11n wireless network. You must install the optional Epson wireless LAN module (part number V12H418P12). Your computer must have a wireless card or built-in wireless interface, and be running Windows 7, Windows Vista®, Windows XP Professional x64, Windows XP, or Windows 2000, or Mac OS X 10.3 to 10.7. 1 Turn off the projector and unplug the power cord. 2 Unscrew and remove the cable cover if necessary. 3 Insert the wireless LAN module into the port.