Epson PowerLite EB-720 Quick Setup - Page 2

Using the remote control Install the two AA batteries as shown. Turn projector on and off Choose which source to display Access projector menus Turn off projector display and sound Navigate projector menus Control projector volume Access the Home screen For more information on using the remote control, see the online User's Guide. Turn on your equipment 1 Turn on your computer or video source. 2 Make sure the power cord is connected and plugged into an electrical outlet. 6 Use the arrow buttons on the remote control to highlight any of the options on the Home screen, then press to select it. 7 The default language of the menu system is English. To select another language, press the Menu button on the remote control. Select Management and press . Select Language and press . Select your language and press . Press the Menu button to exit the menu system. Wireless network configuration Follow these steps to set up the projector for a wireless network connection. 1 Press the Menu button on the remote control. 2 Select the Management menu and press . 3 Select On as the Wireless LAN Power setting. 4 Select the Network menu and press . 5 Select Network Settings and press . 6 Select Wireless LAN as the Priority Control Interface setting. 7 Select one of the following as the Simple AP setting: • On for a direct connection to a computer, tablet, or smartphone. • Off to connect your projector to a router or access point. Note: If you directly connect to the projector, you can only project locallystored content. 8 Select any other wireless settings as necessary. See the online User's Guide for details. 9 When you are finished, return to the Network Settings menu and select Set to apply your settings. 3 Press the power button on the projector or remote control. The projector beeps, and the Status light flashes blue and then stays on. Note: To shut down the projector, press the power button twice. 4 If you don't see an image, press the Source Search button on the remote control to select the image source.  Note: If you still see a blank screen or have other display problems, see the troubleshooting tips on the back of this sheet. 5 If you need to focus the image, first slide the switch on the side of the projector to open the air filter cover. Then raise or lower the focus lever to sharpen the image.