Epson Stylus 1000 Product Information Guide - Page 3

Environmental Temperature: Operation: 10 to 35° C (50 to 95° F) Storage: -20 to 50° C (-4 to 122° F) Humidity (without condensation): Operation: 20 to 80% RH Storage: 5 to 85% RH Safety approvals Safety standards: UL1950 with D3, CSA22.2 #220 R.F.I.: FCC Part 15 Subpart B class B Interface specifications Your printer is equipped with an 8-bit parallel interface, which has the following characteristics: Data format: 8-bit parallel Synchronization: STROBE pulse Handshake timing: BUSY and ACKNLG signals Signal level: TTL compatible Connector: 36-pin 57-30360 Amphenol connector or equivalent Default settings The table below shows the default settings that take effect when the printer is initialized. In addition, hardware and control panel initialization clears the data buffer. Item Top-of-form position Page length Left and right margins Line spacing Character size Vertical tab position Horizontal tab positions Font selection Special printing effects Download character set Default setting Current paper position Single sheets: oo65 lines for A4-size paper oo61 lines for letter-size paper oo22 inches for manual insertion Canceled 1/6-inch line spacing 10.5 point Cleared Every eight characters Last font selected on control panel Canceled (except condensed printing) Hardware initialization: cleared Software/control panel initialization: deselected only EPSON STYLUS 1000 The Control Panel The printer control panel gives you easy control over most common printer operations. It consists of indicator lights and buttons. Indicator lights PAUSE On when printing is paused FONT Indicates the current font setting. These three lights go on and off when you press the FONT button. The font menu on the control panel tells you which font is selected. CONDENSED On when the condensed printing mode is selected. When this mode is selected, the printer prints a condensed version of selected fonts. ECONOMY On when the economy printing mode is selected. When this mode is selected, the printer uses less ink. This mode is ideal for rough drafts. INK OUT On when the ink cartridge runs out of ink. Rapid flashing indicates that ink is low. PAPER OUT On when the printer runs out of paper. Rapid flashing indicates a paper jam. DATA On when data remains in the printer's memory. Buttons RESET Clears the printer's buffer and initializes the printer settings to their factory settings. PAUSE Press this button to stop printing temporarily. Press it again to resume printing. Ink Jet Printers 4/26/94 EPSON STYLUS 1000-3