Epson Stylus Pro 7600 - Photographic Dye Ink Service Manual - Page 130
Ink-related Errors, 2.2.14, Defective ink cartridge, 2.2.15, Ink lever released
View all Epson Stylus Pro 7600 - Photographic Dye Ink manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
EPSON Stylus Pro 7600/9600 Revision A 3.2.2.13 Ink-related Errors Ink End (error) : Ink end error occurs when the defined amount of ink have been consumed after NearEnd is detected. It occurs when NearEnd cartridge is inserted, whether the defined amount of ink have been consumed or not. No Ink Cartridge : There detected any ink cartridge slot without cartridge. Wrong/Non-genuine Ink Cartridge (dye / pigment): This error occurs when wrong ink type (dye / pigment) is installed. Item LCD PANEL MESSAGE LED STATUS Recovery Table 3-17. Description "INK OUT", "NO INK CARTRIDGE" or "INVALID CARTRIDGE" Corresponding color LED lights up Check the CSIC contact terminal on the I/C Holder and the CSIC terminal on the ink cartridge. (damage or deformation) If no problem with the CSIC terminals is found, install a new ink cartridge. 3.2.2.14 Defective ink cartridge Item LCD PANEL MESSAGE LED STATUS Explanation Recovery Table 3-18. Description INK OUT This error occurs when the ink cartridge CSIC has some problems with the contents and has loose connection. Corresponded "INK OUT" LED goes on. There detected some problems with the contents of the ink cartridge CSIC. Reading/writing into ink cartridge was failed. In case of loose connection, release the ink lever (at this time the massage "SET INK" is displayed and reload the ink cartridge. When the error is not recovered, open the ink compartment, and then replace cartridge with new full one. 3.2.2.15 Ink lever released Item LCD PANEL MESSAGE LED STATUS Explanation Recovery Table 3-19. Description SET INK LEVER None It is happen when ink lever is released. Set the ink lever. Troubleshooting Error Display 130