Epson T88IVP Application Guide - Page 5

Version 2.65 Jul. 2009 Section 2. Details on Settings This section describes connection configurations and how to make the settings for the TM-T88IV Series printers. 2.1 References of Firmware Versions Refer to the release notes (Relnote.txt). 2.2 Settings of DIP Switches Confirm that the following settings have been made correctly. 1) Serial port DIP-SW1 DIP-SW2 No. Setting No. Setting 1 OFF Recommended 1 OFF Settable 2 OFF Recommended 2 OFF Settable 3 OFF Fixed at OFF 3 OFF Settable 4 OFF Fixed at OFF 4 OFF Settable 5 OFF Settable 5 OFF Fixed at OFF 6 OFF Settable 6 OFF Fixed at OFF 7 ON Settable 8 OFF Settable 7 OFF Fixed at OFF 8 OFF Fixed at OFF It is possible to change the settings of DIP-SW1-1 (Processing of the data input error) and DIP-SW1-2 (Specification of the received buffer capacity), but it is recommended to leave them OFF. Set DIP-SW1-3 (Handshake) to DTR/DSR. Set DIP-SW1-4 (Bit length) to 8 bits. Set DIP-SW1-5 to DIP-SW1-8 in accordance with the port information. The described set values are the default values. For the details, refer to the product manual of the POSPrinter. Also, if these settings are changed, make sure to change the port information using the SetupPOS utility. Set DIP-SW2-2 in accordance with whether or not a customer display is connected. If connected, set to ON. If not, set to OFF. 2 APPLICATION DEVELOPMENT GUIDE POSPrinter (TM-T88IV)