Epson TM-P80 Plus Product Information Guide PIG - Page 4

Battery Printer condition Power on Power on and buzzer sounds Battery LED 3 LEDs on 2 LEDs on 1 LED on 1 LED flashing 3 LEDs off Error LED Off Off Off On On Battery charge status Level H Level M Level L* Level S** Level E*** * You can continue printing, but replacing or charging the battery is recommended. ** Replace or charge the battery. *** Replace or charge the battery. The printer is unable to print. Buttons Power Press this button to turn the power on or off. To turn the power off, hold the button for more than two seconds. Feed Press this button to advance the paper one line. Hold the button down to advance the paper. 3. Align the two tabs on the paper guide with the slots in the bottom of the roll paper holder. 4. Firmly insert the metal part of the paper guide into the slot at the front of the roll paper holder. Changing the Paper Size Note: The paper size can only be changed on the Mobilink P80 Plus. To change the paper size from 3.15 inches (80 mm) to 3 inches (76 mm), do the following: 1. Turn the printer off. 2. Open the roll paper cover and remove any paper. Note: When installing the paper guides, make sure that the metal part of each guide is facing towards the inside of the printer. Metal parts Paper guides 5. Repeat the above instructions for the other paper guide, then load your paper and close the roll paper cover. Loading Paper Caution: To avoid injury, do not touch any part of the printer other than the roll paper when the cover is open. Note: Do not open the paper roll cover when the printer is printing or feeding paper. Only use paper that meets specifications, and do not use rolls that have the paper glued onto the core. 1. Open the roll paper cover by pressing down on the roll paper cover open button. 2. Remove the used roll paper core, if there is one, and insert the roll paper in the direction shown below. 4 - Mobilink P80 & Mobilink P80 Plus