Epson U300C Operation Manual - Page 25

Adjusting the Paper Near-End Detector Location, Table 3-1., Adjustment Position Number, Diameter

Get Epson U300C - TM Dot-matrix Printer PDF manuals and user guides View all Epson U300C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

3-3 Adjusting the Paper Near-End Detector Location s The paper near-end detector When the paper near-end detector senses that the paper is almost out, the printer turns on the PAPER LED. The PAPER LED also turns on when the paper is completely out or paper roll is not installed. s Adjusting the paper near-end detector Because the paper roll core size differs depending on the paper roll, you may need to adjust the paper near-end detector location. Œ Make sure the paper core inside diameter is 10.5 to 12.5 mm (0.41 to 0.49")  Determine the paper near-end detecting point on your roll paper and measure diameter A as shown below. Ž Find the corresponding adjustment position number from the table below. Table 3-1. Adjustment Position Number Diameter A Adjustment position number 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
3-3
Adjusting the Paper Near-End Detector Location
The paper near-end detector
When the paper near-end detector senses that the paper is almost out, the printer
turns on the PAPER LED. The PAPER LED also turns on when the paper is com-
pletely out or paper roll is not installed.
Adjusting the paper near-end detector
Because the paper roll core size differs depending on the paper roll, you may
need to adjust the paper near-end detector location.
Make sure the paper core inside diameter is 10.5 to 12.5 mm (0.41 to
0.49")
Determine the paper near-end detecting point on your roll paper and measure
diameter A as shown below.
Find the corresponding adjustment position number from the table below.
Table 3-1.
Adjustment Position Number
Diameter A
Adjustment position
number
19