Epson U300C Operation Manual - Page 27

Inserting a Cut Sheet (Validation Paper), to Appendix

Get Epson U300C - TM Dot-matrix Printer PDF manuals and user guides View all Epson U300C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

3-4 Inserting a Cut Sheet (Validation Paper) Be sure to use a validation paper that matches the printer's specifications. Refer to Appendix A, Specifications. Œ Check that the paper is not wrinkled. Using creased or wrinkled paper may cause a paper jam.  Check that the paper roll is already installed. If not, install it first. CAUTION: l Printing with no roll paper installed in the printer may cause damage to the print head pin. Ž After checking that no validation paper is inserted, turn on the power switch. The POWER LED light goes on.  Using printer control command, select validation paper mode. The PAPER LED begins blinking.  Insert the paper straight into the printer using the guide marked with an A in the following illustration. CAUTIONS: l When printing on copy sheets, make sure the glued (fixed) edge is positioned as shown in the illustration above. l After you insert validation paper, do not move the paper. Moving the paper may cause the paper to slip. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
3-4 Inserting a Cut Sheet (Validation Paper)
Be sure to use a validation paper that matches the printer’s specifications. Refer
to Appendix A,
Specifications.
Check that the paper is not wrinkled.
Using creased or wrinkled paper may
cause a paper jam.
Check that the paper roll is already installed.
If not, install it first.
CAUTION:
l
Printing with no roll paper installed in the printer may cause damage
to the print head pin.
After checking that no validation paper is inserted, turn on the power switch.
The POWER LED light goes on.
Using printer control command, select validation paper mode. The PAPER
LED begins blinking.
Insert the paper straight into the printer using the guide marked with an A in the
following illustration.
CAUTIONS:
l
When printing on copy sheets, make sure the glued (fixed) edge is
may cause the paper to slip.
positioned as shown in the illustration above.
l
After you insert
validation paper, do not move the paper. Moving the paper
21