Epson WorkForce Pro WF-M4119 Users Guide - Page 188
Configuring Wi-Fi Direct Settings, Settings, General Settings, Network Settings, Network Status
View all Epson WorkForce Pro WF-M4119 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
Administrator Information > Managing the Printer > Managing the Network Connection You can check the IP address of the printer from the following menu. Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status 2. Enter the administrator password to log in as an administrator. 3. Select in the following order. Network tab >Wired LAN 4. Set each item. ❏ Link Speed & Duplex Select the communication mode from the list. ❏ IEEE 802.3az You can specify whether or not to enable IEEE 802.3az. 5. Click Next. A confirmation message is displayed. 6. Click OK. The printer is updated. Configuring Wi-Fi Direct Settings You can check or configure the Wi-Fi Direct Settings. Note: For models that support Wi-Fi, this item is displayed when the Wireless LAN Interface is installed. 1. Enter the printer's IP address into a browser to access Web Config. Enter the printer's IP address from a computer that is connected to the same network as the printer. You can check the IP address of the printer from the following menu. Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status 2. Enter the administrator password to log in as an administrator. 3. Select in the following order. Network tab >Wi-Fi Direct 4. Sets each item. ❏ Wi-Fi Direct You can specify whether or not to enable the Wi-Fi Direct. ❏ SSID You can change the SSID (Network Name).whether or not to enable ❏ Password When changing the Wi-fi Direct password, enter a new password. ❏ Frequency Range Select the frequency range to be used in Wi-Fi Direct. 188