Epson WorkForce WF-7010 Start Here - Page 2
Load paper in the cassette
View all Epson WorkForce WF-7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
4 Load paper in the cassette You can load letter-, A4-, or legal-size paper in the cassette. For instructions on loading envelopes and using the rear tray, see the online User's Guide. 1 Pull out a paper cassette, and remove the cover. 5 Replace the cover and gently insert the paper cassette. 2 Slide the edge guides outward. 6 Extend the output tray and raise the stopper as shown. (If you are loading legal-size or A3 paper, do not raise the stopper.) N ote: Before loading legal or A3 paper, extend the cassette as shown. 3 Insert the paper with the glossy or printable side face down. 5 Choose your connection You can connect your printer to your existing network using an Ethernet® cable, or directly to your computer using a USB cable. See below for details on each connection method. Note: Do not connect the printer to your computer until you're instructed to do so. Direct USB connection Make sure you have a USB cable. (Not included.) Wired Ethernet connection Make sure you have an Ethernet network cable. (Not included.) You must install the software on every computer from which you want to print. 4 Slide the edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the edge guides. 6 Install software Note: If your computer does not have a CD drive, you can download the software from the Epson website, as described under "Epson technical support." 1 Make sure the printer is NOT CONNECTED to your computer. Windows®: If you see a Found New Hardware screen, click Cancel and disconnect the USB cable. You can't install your software that way.