Epson XP-600 Quick Guide - Page 28

Cannot Scan Over the Network ■ EPSON Scan is not installed in Mac OS X 10.6 or 10.7; see page 18 for scanning and download instructions. ■ If you cannot scan from the product's touch panel, make sure you restarted your computer after installing the product software. Make sure EPSON Event Manager is not being blocked by your firewall or security software. Try turning off the firewall. ■ If you are scanning a large document at high resolution, a communication error may occur. If the scan did not complete, lower the scan resolution. ■ If network communication was interrupted while starting EPSON Scan, exit EPSON Scan and restart it after a few seconds. If EPSON Scan cannot restart, turn the product off and on, and then try again. Check the Timeout Setting in EPSON Scan Settings. For details, see the EPSON Scan Help. ■ Make sure EPSON Event Manager is set up to communicate with your product. Print a Network Status Sheet 1. Press if necessary, press l or r to select Setup, then press OK. 2. Press u or d to select Wi-Fi/Network Settings, then press OK. 3. Press u or d to select Wi-Fi Status, then press OK. 4. Press x twice to print the status sheet. Printing and Copying Problems ■ When loading paper in the paper cassettes, make sure it is loaded facedown (usually the whiter, brighter, or glossy side) and under the edge guides. ■ Make sure the paper size and source selected on the touch panel or in your printer software is correct for the paper you loaded. ■ When scanning, position your original with the bottom against the front right corner of the scanner glass. If the edges are cropped, move it away from the corner slightly. ■ You cannot print or copy when an ink cartridge is expended. Replace any expended cartridges before printing. ■ To select two-sided printing in Mac OS X, choose 2-sided Settings from the pop-up menu. Do not select Layout from the pop-up menu. 28 Solving Problems