Epson XP-970 Start Here - Installation Guide - Page 1

XP-970 Small-in-One® Printer Start Here 3 Lower the scanner unit. IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User's Guide. Note: This printer is designed for use with Epson® cartridges only, not third-party cartridges or ink. For important ink information, visit www.epson.com/epsonink (U.S.) or www.epson.ca/epsonink (Canada) or see your printer box. 1 Unpack 2 Turn on and configure 1 Connect the power cord to the back of the printer and to an electrical outlet. Extra maintenance box Note: • Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability. • The CD/DVD tray is stored underneath cassette 2. • Your product includes an extra maintenance box. Use it to replace the installed maintenance box when you are prompted to do so. For instructions on how to replace the maintenance box, see the online User's Guide. 1 Remove all protective materials from the product. Caution: Do not connect to your computer yet. 2 Turn on the product. 3 Select your language. Note: • You can change this setting later using the product's control panel. For more information, see the online User's Guide. • If an error message appears, turn off the product and check that no protective material has been left inside the product. 2 Lift up the scanner unit. Remove all protective materials from inside the product. 3 Install ink cartridges Caution: Keep the ink cartridges out of the reach of children and do not drink the ink. Note: The included initial cartridges are designed for reliable printer setup and cannot be used as replacement cartridges or resold. After setup, the remaining ink is available for printing. 1 Lift up the scanner unit. Note: Do not throw away the protective material shown above. Tape this piece to the top of the ink cartridge holder when transporting your product. For more information, see the online User's Guide. Caution: Do not touch the flat white cable or the print head path.