Eufy RoboVac 11S RoboVac 11S11S Max15C Max_EU_Manual - Page 10

D. Quick cleaning RoboVac will automatically stop cleaning after 30 minutes and return to the Charging Base in this mode. If any small room or area needs to be cleaned, it is recommended to select this mode to save time and power. Press on the remote control to start quick cleaning mode. E. Manual cleaning You can direct RoboVac to clean a particular area by using the directional buttons on the remote control. 16 EN Turn left Move backward Move forward Turn right Set Time and Scheduled Cleaning Set Time • Make sure the time is set correctly to your local time before setting a scheduled cleaning. • For 15C Max (T2128) without the remote controller, you can directly set time and scheduled cleaning via eufy Clean app. 1 Make sure the main power switch on the bottom of RoboVac is turned on. 2 Press on the remote control. The time will blink on the display. 3 Press to set the "hour" and "minute". 4 Press or to save the setting. RoboVac will BEEP ONCE to indicate the time has been set. ON 1 4 • To ensure the time is set successfully, make sure RoboVac is turned on. You will hear a beep when the time has been set. Set a Scheduled Cleaning You can schedule RoboVac to start cleaning at a specified time. • Before setting a scheduled cleaning, make sure the time has been set correctly to your local time; refer to the previous section "Set Time" for how to set the time. 1 Make sure the main power switch on the bottom of RoboVac is turned on. 2 Press on the remote control. The time will blink on the display. 3 Press to set the "hour" and "minute". 4 Press or to save the setting. RoboVac will BEEP ONCE to indicate the schedule has been set. ON 1 4 5 To cancel a previously scheduled clean, press and hold for 3 seconds until RoboVac beeps twice and the icon disappears. • To ensure the schedule is set successfully, make sure RoboVac is turned on. You will hear a beep when the schedule has been set. Cleaning and Maintenance For optimal performance, follow the instructions below to clean and maintain RoboVac regularly. The cleaning/replacement frequency will depend on your usage habits of RoboVac. Recommended Cleaning and Replacement Frequency RoboVac Part Cleaning Frequency Replacement Frequency Dust Collector Filters Rolling Brush After each use Once every week Once every week Side Brush Once every month Brush Guard Once every month Sensors Charging Pins Swivel Wheel Once every month Once every month Once every month - Every 2 months Every 6-12 months Every 3-6 months (or when visibly worn) Every 3-6 months (or when the silicone rubber strip on the brush guard becomes visibly worn) - - - EN 17