Eufy RoboVac 11S RoboVac 11S11S Max15C Max_EU_Manual - Page 7

E. Remote Control Display panel 1 Start Auto cleaning 2 Start Auto cleaning / Stop cleaning 3 Start Quick cleaning 4 Start Spot cleaning 5 Start Edge cleaning 6 Adjust time 7 F. Remote Control Display 10 EN Returning to Charging Base 1 Auto cleaning mode selected 2 Spot cleaning mode selected 3 Edge cleaning mode selected 4 Quick cleaning mode selected 5 11 Adjust suction power level in Auto and Quick Cleaning modes 10 Control cleaning direction manually / Adjust the hour and minute 9 Return RoboVac to Charging Base 8 Schedule Auto cleaning start time 6 Clock 7 Standard suction power enabled 8 BoostIQ™ dynamic suction power enabled 9 Max suction power enabled 10 Scheduled cleaning time • Install 2 AAA batteries before using the remote control for the first time. Make sure the positive and negative ends are facing the correct polarity direction as marked in the battery compartment. LED Indication You can see the status of RoboVac from the LED indicator. Using Your RoboVac Important Tips Before Use A B C Status (Status Light) Breathing orange Charging Solid blue Standby / Cleaning / Fully charged Solid orange Low power and returning to Charging Base Off Flashing / Solid red + Beeping • RoboVac is off. • To conserve power, the light automatically turns off when RoboVac is not docked to the Charging Base and has been inactive for 1 minute. • RoboVac has an error. • Refer to the "Troubleshooting>Error Tone" section in this manual for solutions. Remove power cords and small objects from the floor that may entangle RoboVac. Fold tasseled edges of rugs underneath to prevent tangling RoboVac. Avoid cleaning dark-colored high-pile rugs or rugs thicker than 1.02 in / 26 mm as they may cause RoboVac to malfunction. It is strongly recommended to place physical barriers in front of fireplaces and certain areas (i.e. air vents) that may cause damage to RoboVac if entered. D E F EN 11