Fender Standard Series Owners Manual - Page 14

the center of the body should be loosened approximately 2 turns. Insert the special 118" Allen wrench (supplied with the instrument) into the hole in the neck mounting plate. Rotate the wrench, gently, until you feel it engage in the hexhead slot. Turn the wrench clockwise if you wish to increase the amount of neck angle, counterclockwise if you wish to decrease the amount of neck angle. After the adjustment is complete, re-tighten the four neck plate screws, being careful not to over tighten. The screws should be tightened until they feel completely seated, but should not be forced. Overtightening can cause cracking of the fretboard. Re-check the alien screw to make sure it is not left loose to vibrate. CARE OF YOUR FENDER GUITAR Your new Fender Standard Series guitar is precision made to give you many years of satisfaction. A few simple maintenance procedures will help you keep your instrument playing like new. After you have finished playing, thoroughly wipe the entire guitar, including the strings, with a clean, soft cloth. A regular routine for cleaning your instrument with Fender Polish is recommended. Avoid exposing the guitar to any chemical or substance that might mar the finish, as well as, to direct sunlight or other sources of excessive heat, humidity or shock. You must use extreme caution when a thoroughly chilled instrument is to be played. It is 12