Fisher and Paykel DD24DCTX6 User Guide - Page 30

USCA 28 User maintenance instructions Cleaning the spray arm and filter plate Ensure the DishDrawer® is cool before you start cleaning and follow the instructions for removing the drain filter and spray arm. 1 Unclip the glass supports from the rack wires and fold all the adjustable racks away, so that they are 1 1 upright and close to the top. 2 Remove the base rack carefully. Lift from the 2 back end first to prevent knocking the detergent and rinse agent dispenser. 3 Lift the spray arm and shake any foreign material out. Rinse the spray arm clean under running water and wipe the with a damp cloth. 4 In the center of the filter plate there are two rings. 2 3 4 4 1 3 Hold the center ring still and turn the outer ring 5 counter-clockwise, about a 1/8 turn. This will release the filter plate. 5 Lift the filter plate out. When cleaning the underside of the filter plate, take care handling the sharp outer edge to avoid a the risk of cuts. Remove any foreign material, wash in hot soapy water and rinse thoroughly in clean water. The heater plate can be wiped with a damp cloth. b e 6 Replace the filter plate so it lies flat in the base of the drawer ensuring the filter plate is fully locked c into position with the center ring. Important! To lock the filter plate into position, ensure the lines align with each other (c) and all three pin pairs firmly interlock (e). Refer to the diagram for the correct position. The filter plate must not be able to move about freely. 7 Replace the spray arm back onto the impeller. 8 Replace the base rack, lowering its front edge into position first. d Correct locking position of filter plate with motor assembly (under spray arm) a Outer ring b Impeller c Correct alignment marks Note: Where there is broken crockery or glass in the drawer, it must be carefully removed to prevent damage to the DishDrawer®. d Center ring e Interlocking pins