Fisher and Paykel DD24DCTX7 BOOK USER DISHDRAWER PH7 (EN) (English) - Page 40

36 How to attend to a fault ‐ Designer models START HERE Press to stop the beeping. Try to open the drawer (without using excessive force). Can the drawer be opened? NO Press . Wait a few seconds, then press YES again. If it's a 'U' code Check which program indicators are lit on the wash program panel. Look up what fault code the indicators correspond to in the table opposite. Note down the code here: Is the light above the button still red? If it's an 'E' code NO, YES IT'S BLUE U1: Turn on the water supply, then press to resume the wash program. U4: Attend to the fault on the other drawer. The drawer displaying U4 is not faulty. U6: Open the drawer and check the spray arm. Press . Wait a few seconds, then press again. Is the light above the button still red? YES NO, IT'S BLUE The fault has reset and you should now be able to open the drawer. You can continue to use it as normal. Has the spray arm loosened or come off its mounting? YES NO Refit the spray arm following instructions in section 'User maintenance instructions', then close the drawer and press to resume the wash program. Water pressure is too low. You may need to have a '4 litre' valve installed on your water supply. Has the fault code disappeared? Has the dishwasher resumed normal operation? YES Press . The Eco indicator and another set of program indicators will briefly light up on the wash program panel. Mark which ones in the diagram below. This information will help Fisher & Paykel identify the fault more precisely. Which other indicators light up when you press ? Disconnect the dishwasher from the power supply (unplug or switch off at circuit breaker), turn off its water supply, NO then contact Customer Care with the fault code information. See your 'Service and warranty' booklet for contact details. You have corrected the fault and can continue to use your dishwasher as normal.