Fisher and Paykel DD24DCTX7 BOOK USER DISHDRAWER PH7 (EN) (English) - Page 44
How to attend to a fault ‐, Integrated models with remote control
View all Fisher and Paykel DD24DCTX7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
40 How to attend to a fault ‐ Integrated models with remote control START HERE Try to open the drawer (without using excessive force). Can the drawer be opened? YES If it's a 'U' code Press on the wash program panel to stop the beeping, then follow the applicable instructions below. Check which program indicators are lit on the wash program panel. Look up what fault code the indicators correspond to in the table opposite. Note down the code here: U1: Turn on the water supply, press , then close the drawer to resume the wash program. Disconnect the dishwasher from the NO power supply to stop the beeping, then contact Customer Care. See your 'Service and warranty' booklet for contact details. If it's an 'E' code Press and hold until you hear a quick double beep. Do the fault code indicators and beeping come back in a few seconds? YES NO U4: Attend to the fault on the other drawer. The drawer displaying U4 is not faulty. U6: Open the drawer and check the spray arm. Has the spray arm loosened or come off its mounting? YES NO Refit the spray arm following instructions in section 'User maintenance instructions', then close the drawer and press to resume the wash program. Water pressure is too low. You may need to have a '4 litre' valve installed on your water supply. You have corrected the fault and can continue to use your dishwasher as normal. Press on the wash program panel. The Eco indicator and another set of program indicators will briefly light up. Mark which ones in the diagram below. This information will help Fisher & Paykel identify the fault more precisely. Which other indicators light up when you press ? Has the fault code disappeared? Has the dishwasher resumed NO normal operation? YES You have corrected the fault and can continue to use your dishwasher as normal. Disconnect the dishwasher from the power supply (unplug or switch off at circuit breaker), turn off its water supply, then contact Customer Care with the fault code information. See your 'Service and warranty' booklet for contact details.