Fisher and Paykel E522BRXFDU User Guide - Page 8
complete, turn isolating faucet off.
View all Fisher and Paykel E522BRXFDU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
6 Installation instructions Installation instructions: 1 Ensure that refrigerator is not plugged into a power supply. 2 Locate a cold water supply/feed only suitable for a water connection. Tee & tap fitting is not supplied. If you can't find the connection faucet, contact an authorised plumber in your state or town to fit your water connection. 3 Connect the 8" (200 mm) blue tubing to the outlet of the PRV (blue collet) and the inlet connection of the water filter cartridge as shown in Diagram 1. Gently pull on both ends to ensure it is locked. 4 Connect the white ¼" (6 mm) tubing to the outlet of the water filter cartridge as shown in Diagram 2. Gently pull to ensure it is locked. 5 Measure the required length of tubing to run from the PRV to the water connection point. 6 Cut the tubing making sure the ends are square and clean. 7 Connect the tubing to the faucet connection and the base of the PRV (white collet) and then to the faucet as shown in Diagram 3. Please note that the faucet connection supplied should fit most installation situations. If your faucet requires a different fitting, please contact an authorised plumber in your state or town to purchase the correct fitting. 8 Connect one locking key to each side of the water filter cartridge in between the cartridge and the locking collet as shown in Diagram 4. 9 To flush the water filter and check for leaks, aim the end of the tubing into a bucket, turn isolating faucet on and run at least 3 qt (3 L) of water through. Once complete, turn isolating faucet off. 10 Locate desired position for water filter noting carefully the following points: It is recommended to fit the water filter in a vertical orientation with the water filter head at the top. This will minimize water leakage when replacing cartridge. Ensure the filter is in a convenient location to access every 6 months for replacement. We suggest that this location is beside the water filter supply faucet in a cupboard beside the refrigerator. A minimum clearance of 2 ½" (64 mm) from the bottom of the filter cartridge is required to perform cartridge removal. Do not screw water filter to refrigerator. INLET Diagram 1 Fig.3 PRV connection Diagram 2 Fig.4 Waterline connection to refrigerator Diagram 3 Fig.5 Faucet connection Diagram 4 Fig.6 Locking key