Fluke 107 ESP Product Manual - Page 5
Remove the input signals before you clean the Product., individual component of a Product, probe
View all Fluke 107 ESP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
106/107 Users Manual • Do not use test leads if they are damaged. Examine the test leads for damaged insulation and measure a known voltage. • Do not apply more than the rated voltage, between the terminals or between each terminal and earth ground. • Do not use the HOLD function to measure unknown potentials. When HOLD is turned on, the display does not change when a different potential is measured. • Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc. • Keep fingers behind the finger guards on the probes. • Remove all probes, test leads, and accessories before the battery door is opened. • Do not exceed the Measurement Category (CAT) rating of the lowest rated individual component of a Product, probe, or accessory. • Remove the input signals before you clean the Product. • Have an approved technician repair the Product. • Remove the batteries if the Product is not used for an extended period of time, or if stored in temperatures above 50 °C. If the batteries are not removed, battery leakage can damage the Product. 4 MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664