Fluke 279FC User Manual - Page 40

Display Hold, when a different potential is measured.

Get Fluke 279FC PDF manuals and user guides View all Fluke 279FC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

279 FC Users Manual 5. To exit and erase the MIN, MAX, and AVG values, push  for 1 second or turn the rotary switch. 6. To see the other recorded values (minimum and average), push . Each push of  steps through the recorded value for MAX, MIN, or AVG. When no label shows in this display location, the display shows the live input signal measurement. Note Auto Off (battery save) is disabled in MIN MAX AVG record mode. Display Hold XW Warning To prevent possible electrical shock, fire, or personal injury, do not use the HOLD function to measure unknown potentials. When HOLD is turned on, the display does not change when a different potential is measured. In the display hold mode, the Multimeter holds the measurement on the display. To hold a measurement on the display: 1. Push . The display shows  when display hold is turned on. 2. Push  again to stop hold mode and show measurements on the display. 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
279 FC
Users Manual
30
5.
To exit and erase the MIN, MAX, and AVG values, push
for 1 second or turn the rotary switch.
6.
To see the other recorded values (minimum and
average), push
.
Each push of
steps through the recorded value for
MAX, MIN, or AVG. When no label shows in this display
location, the display shows the live input signal
measurement.
Note
Auto Off (battery save) is disabled in
MIN
MAX
AVG record mode.
Display Hold
XW
Warning
To prevent possible electrical shock, fire, or
personal injury, do not use the HOLD function
to measure unknown potentials. When HOLD
is turned on, the display does not change
when a different potential is measured.
In the display hold mode, the Multimeter holds the
measurement on the display.
To hold a measurement on the display:
1.
Push
.
The display shows
when display hold is turned on
.
2.
Push
again to stop hold mode and show
measurements on the display.