Fluke 710 Product Manual - Page 14
mA Simulate, Valve Test, mA Simulate Connections
View all Fluke 710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Shop for Fluke products online at: www. mA Simulate In the mA Simulate mode, the Product functions like a 2-wire transmitter and controls the loop current from an external power supply. This function can test a loop with the transmitter removed. Figure 5 shows the mA Simulate home screen and typical connections for this mode. To use mA Simulate: 1. Select mA Simulate from the Main menu. 2. Push the selection knob to move the decade cursor. 3. Turn the selection knob to increment or decrement the output in steps indicated by the selected decade. 4. Push , , or to set the output to preset values. 5. Push to select and stop these advanced modes. When automatic step or ramp is active, one of the subsequent icons shows in the lower left corner: • Automatic step: • Automatic ramp: 6. Push to go to the Main menu. 7. Push again to go to the mA Simulate home screen. • Valve Test shows in the lower center when the valve test function has been enabled on the Setup menu. See the Valve Test. • 250Ω shows in the lower right corner when the HART resistor has been enabled on the setup menu. Precision Loop Calibrator Main Menu PoPwoweer rSSuuppppllyy 303V0 VdcdcMMaaxx 4 4mmAAtoto2200mmAA 4 m4 AmAto-2200mmAA InpInuptuDt eDveivciece Figure 5. mA Simulate Connections MyFlukeStore.com 1.888.610.7664 9