Frigidaire FAHE4044MW Complete Owner's Guide (English) - Page 9

OPERATING INSTRUCTIONS Cycle Selection, continued Cycle Settings quick wash Quickly wash a small, lightly soiled. kids wear Wash normally-soiled kids wear and baby wear with this specialty cycle. wool Designed for a small load of machine-washable woolen items, the wool cycle uses gentle washing action along with cold rinses to eliminate shrinking and damage to wool. You may use an wool detergent approved for automatic washers. whites Use this cycle for white fabrics and lightly colored clothing. Refer to fabric care label for use of liquid chlorine bleach. Hot water is recommended to ensure optimal bleach activation. For peak rinsing performance and to avoid chlorine residues on your laundry add fresh rinse to this cycle. drain & spin Use the drain & spin cycle anytime you want to drain water from the washer and spin out the load. rinse & spin Select rinse & spin for loads that need a cold water rinse or to add fabric softener that may have been omitted in a regular cycle. presoak Use this cycle to soak heavily soiled and stained items before washing. Any temperature except hot may be selected, but cold water is recommended with this cycle as warmer water may set some stains. Use the amount of detergent recommended for a normal wash cycle. If desired, use a bleach or a soaking agent safe for the fabric. The washer will drain at the end of the cycle. For best results Follow the fabric care label instructions on items to be washed. Appropriate wash water temperature, soil level, spin speed, water level and options will automatically be displayed for each cycle. The settings can be modified before the cycle is started. Make modifications according to fiber content, colorfastness and soil level. Modifications for each cycle will be remembered and recalled each time that cycle is selected in the future. To return to factory settings, press these two buttons at the same time and hold until the signal sounds. If changes are attempted after the cycle starts, the lights will flash and a signal will beep, but the cycle will continue. Í NOTE To change the settings once the cycle has begun, push in the cycle selector knob to pause the cycle, make the new selections and push in the selector knob again to restart the washer. Í NOTE Follow presoak with a complete wash cycle suitable for the load using a half dose of detergent. casual Use this cycle for poly blends with a permanent press or no-iron finish. 9