Frigidaire FAK085R7V Installation Instructions (All Languages) - Page 10
Drill two screw-clearance holes
![]() |
UPC - 012505272028
View all Frigidaire FAK085R7V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
11. Cut side channel seal into 2 equal lengths. Remove the protective backing and apply it to the rear side of the cabinet side channels, starting just below the panel frame assembly. Pinch off excess length so the seal is even with the bottom of the cabinet side channel. 12. To remove front 1. Remove the two front retaining screws from the front frame. 2. Press firmly on each side of the metal case close to the front, approximately 2/3 of the way down. 3. While pressing on the sides of the metal case, gently pull the front out and lift up to release it from the case. 4. Then release the electrical coupler plug. NOTE: DO NOT push or pull air direction louvers. Apply weather seal to side channels just below edge of panel frame. 13. Place the air conditioner in the window opening as shown to the right. It should sit on the platform assembly so that the window panel frame, and the cabinet side channels are against the top and side window jambs. Side channels should overlap side window jambs equally. 14. Drill two 9/64-inch diameter pilot holes in the top window jamb in line with the partially plugged holes in the panel frame. Secure the panel fame to the window jamb with two #8-32x3/4-inch selfthreading screws. If additional holding is necessary, two screws may be used on the sides of the panel frame as well. 15. Drill two screw-clearance holes in the cabinet side channels (near bottom) and two 9/64-inch diameter pilot holes in the side window jambs. Secure the cabinet side channels to the window jambs with two #8-32x3/4-inch self-threading screws. When doing this, be careful not to twist the side channel seals with the screws. NOTE: Inserting screws will prevent the air conditioner from being pushed into the room. 16. To replace the front First reconnect the coupler plugs, make the exhaust control positioned through the front in the proper location. Gently push the front into position on the cabinet. It should click into place. Then replace the retaining screws that holds the panel in place. Do not push or pull the front panel louvers. 10
![](/manual_guide/products/frigidaire-fak085r7v-installation-instructions-languages-a6a41a5/10.png)