Frigidaire FASE7021NW Installation Instructions (All Languages) - Page 16

INSTALLATION INSTRUCTIONS Water connection, continued (Steam Model only) 5 If your installation has room for the COLD water supply to accept the "Y" connector directly, thread the "Y" connector to the COLD water supply and snug it by hand; then tighten it another 2/3 turn with pliers. Í NOTE If you were able to install the "Y" connector directly to the COLD water supply, please skip to step 8. 6 If there is not room to install the "Y" connector directly, thread a short extension hose on to the COLD water supply and snug it by hand; then tighten it another 2/3 turn with pliers. Í NOTE Short extension available from your local hardware supplier. Extension hose must meet qualifications for use in laundry installation. 7 Thread the "Y" connector to the short extension hose and snug it by hand; then tighten it another 2/3 turn with pliers. 8 Connect the COLD inlet hose for the washer to the "Y" connector and snug it by hand; then tighten it another 2/3 turn with pliers. 9 Connect the straight end of the long hose from the kit to the other outlet on the "Y" connector and snug it by hand. Connect the hose's 90° coupling to the brass water inlet on the back of the dryer and snug it by hand. Tighten each connection of the dryer inlet hose another 2/3 turn with pliers. 10 Turn on the water and check for leaks at all connections. DIRECT CONNECTION OR WITH EXTENSION* WATER INLET ON DRYER COLD WATER SUPPLY HOSE TO WASHER *Laundry hose extension not included with dryer. 16