Frigidaire FEB24S5AS Installation Instructions (All Languages) - Page 4
Adjusting Oven Height, Electrical connection - wall oven
UPC - 057112080680
View all Frigidaire FEB24S5AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS Wait at least three (3) hours after receiving this built-in oven before switching the power on to prevent possible damage to the built-in oven control at power on. OVEN DOOR 3. Adjusting Oven Height A. Models with extension panel (some models only): Remove and lay aside the lower vent decorative trim that is taped to the outer side panel of the oven. The decorative trim will be fastened to the lower front of the oven after it has been installed in the cabinet. There is a 1 1/2" (3.8cm) height adjustment on models with extension panel (see figure 3). With this adjustment and a 1/2" (1.2cm) trim overhang, a unit can be installed in existing openings 48" (121.9cm) to 50" or 49 7/8" (127cm or 126.7cm) high (for double oven) or 28 1/8" (71.4cm) to 30 1/8" (76.5cm) (for single oven). OVEN BOTTOM Figure 4 EXTENSION PANEL 4. Electrical connection It is the responsibility and obligation of the consumer to contact a qualified installer to assure that the electrical installation is adequate and is in conformance with the National Electrical Code ANSI/NFPA No. 70-latest edition, or with CSA Standard C22.1, Canadian Electrical Code, Part 1, and local codes and ordinances. ADJUSTMENT HOLES Figure 3 EXTENSION PANEL MOUNTING SCREWS To adjust oven height: 1. Lay oven on its back. (see figure 4). 2. Remove the 6 screws that fasten the side extension panel to the bottom sides of the oven. 3. Move each panel down to the position that increases the oven height to fit your opening. Each position changes oven height approximately 1/2" (1.3cm). 4. Line up the appropriate holes in the side extension panels and sides of the oven. Put back the 6 screws. 5. Proceed with oven installation. Return to upright position. Risk of electrical shock (Failure to heed this warning may result in electrocution or other serious injury.) This appliance is equipped with copper lead wire. If connection is made to aluminum house wiring, use only connectors that are approved for joining copper and aluminum wire in accordance with the National Electrical Code and local code and ordinances. When installing connectors having screws which bear directly on the steel and/or aluminum flexible conduit, do no tighten screws sufficiently to damage the flexible conduit. Do not over bend or excessively distort flexible conduit to avoid separation of convolutions en exposure of internal wires. DO NOT ground to a gas supply pipe. DO NOT connect to electrical power supply until appliance is permanently grounded. Connect the ground wire before turning on the power. B. Models without extension panel (some models only): Oven height can be adjusted with 2" (5cm) wide wood shims when needed to fit into an existing cabinet cutout opening, when cutout height exceeds H Min. dimension (see Figure 1 or 2). 4