Frigidaire FFAD3533W1 Complete Owners Guide - Page 6

Operating Instructions Operating Instructions (continued) 5. The Filter reset light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the Filter reset button to extinguish the light. 6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours. If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start). TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the or button to change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated. NOTE: 1. Before entering TIMER setting, make sure power is being supplied to the unit. 2. Before entering TIMER setting, make sure pressing HUMIDITY or button sets one desired room humidity first. 7. To shut the unit down, press the ON/OFF button. Note: After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored. 6 2019 Electrolux Home Products, Inc. All rights reserved.