Frigidaire FFGF3012TW Complete Owner s Guide - Page 26
Removing and replacing surface burners, Cleaning under cooktop
![]() |
View all Frigidaire FFGF3012TW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
CARE AND CLEANING To clean the surface burner heads: For proper gas flow, it may be necessary to clean the burner ports. Before cleaning be sure the gas burners are turned off. First use a clean DAMP cloth to soak up any spills. Remove any food from the burner ports using a small non-abrasive brush like a toothbrush, and afterwards wipe up using a damp cloth. For stubborn soils located in the burner ports, use a small gauge wire or needle to clean. Any spill on or around the igniter must be carefully cleaned. Take care not to hit the igniter with any thing hard, or it could be damaged. Cleaning under cooktop cooktop support rods Figure 15: Raise cooktop WARNING DO NOT turn the burners on when the cooktop is raised for cleaning. Be sure that the top is completely lowered and securely in place before turning on the surface burners. Figure 14: Burner shipping screws Removing and replacing surface burners To remove burners: 1. Remove the shipping screws with a Phillips Head screwdriver. See Figure 14 for screw locations. 2. Tilt the burner at the end closest to the support bar until the locator tab is released (front burners tilt right, rear burners tilt left). Move the burner towards the back of the range. This will separate it from the gas valve at the front of the range. To replace burners: 1. Slide the burner tube over the gas valve at the front of the range (front burners fit over the right valve, rear burners fit over the left valve on each side of the range). 2. Tilt burner so that the locating tab will slide into the slot on the support bar. Make sure burners are properly seated on support bar and are level. 3. Replace the shipping screws. To raise the cooktop for cleaning: 1. Remove burner grates when cool from cooktop and set aside. 2. Grasp the sides of the cooktop and then lift from the front (see Figure 15). 3. Lift the top high enough to allow the support rods to snap into place. The lift-up rods will support the cooktop in the raised position. 4. If necessary, clean underneath using hot, soapy water and a clean cloth; then, dry. 5. To lower the cooktop, grasp the front corner of each side of the top while pushing back on each rod with the heel of your hand. This will release the notched support. Hold the range top and gently slide the range top down to the range. CAUTION When lowering the lift-up range cooktop, grasp the sides with finger-tips only. Be careful not to pinch fingers. Do not drop or bend the range cooktop when raising or lowering. This could damage the cooktop surface. 26
![](/manual_guide/products/frigidaire-ffgf3012tw-complete-owner-s-guide-8a341cb/26.png)