Frigidaire FFRA2822U2 Installation Instructions - Page 1
Frigidaire FFRA2822U2 Manual
View all Frigidaire FFRA2822U2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions For BY Platform (15,000-18,500 BTU) + BN Platform (22,000-28,500 BTU) Air Conditioner READ BEFORE INSTALLING UNIT INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. Follow each step as shown. Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only. Pay attention to danger and safety notices. To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed: Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To prevent injury or strain, use proper lifting and carrying techniques when moving unit. Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended period of time. Handle air conditioner with care. Make sure air conditioner does not fall during installation. If a new electrical outlet is required, have the outlet installed by a qualified electrician before installing unit. NOTE: DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED HERE. Preliminary instructions: Do the following before starting to install unit. See illustrations below. window sash seal Check dimensions of your unit to determine model type: BY Platform BN Platform Capacity: 15,000~18,500 BTU 22,000~28,500 BTU safety lock and 1/2" long hex head screw Unit Height: 17-25/32" 18-5/8" foam gasket Unit Width: Min. Window Opening: 23-5/8" 19-1/4" 26-17/32" 19-1/4" washer head locking screw top angle Min. Window Width: 29" Max. Window Width: 41" 30" frame assembly 41" (left) 1. Check window opening size: the mounting parts furnished with this air conditioner are made to install in a wooden sill double-hung window. The standard parts are for window dimensions listed above. Open sash to a minimum of 19-1/4"(489mm). (FIG.1) 2. Check condition of window: all wood parts of window must be in good shape and able to firmly hold the needed screws. If not, make repairs before installing unit. 3. Check your storm windows: If your storm window frame does not allow the clearance required, correct by adding a piece of wood as shown (FIG.2), or by removing storm window while room air conditioner is being installed. FIG.1 side retainer bottom rail seal to unit 1/2" long screws and locknuts locknut 3/4" long flat head bolt window support bracket sill angle bracket FIG.2 frame assembly (right) sash sash 1/2" min 19-1/4" min inner sill outer sill storm window frame or other obstruction 1/2" min 19-1/4" min 1-1/2" min inner sill outer sill storm window frame or other obstruction board thickness as required, along entire inner window sill; fasten to inner sill with two nails or screws. 1 66129926912