Frigidaire FGGF304DLF Complete Owner's Guide (English) - Page 33
Solutions to Common Problems - review
UPC - 057112105550
View all Frigidaire FGGF304DLF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
before you call (Solutions to Common Problems) IMPORTANT Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE POSSIBLE CAUSE/SOLUTION Range is not level. Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the rack is level. When range is level, cooktop may appear out of alignment if countertop is not level. Weak, unstable floor. Be sure floor is level and can adequately support range. If floor is sagging or slopping, contact a carpenter to correct the situation. Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are square and have sufficient room for range clearance. Cannot move appliance easily. Appliance must be accessible for service. Cabinets not square or are built in too tight. Contact a cabinet maker to correct the problem. Contact builder or installer to make appliance accessible. Carpet interferes with range. Provide sufficient space so range can be lifted over carpet. Gas line is hard-plumbed. Have a flexible C.S.A international approved metal appliance connector installed. Entire range or oven Make sure cord/plug is plugged tightly into outlet. does not operate. Service wiring is not complete. Call an authorized servicer. Electrical power outage. Check house lights to be sure. Call your local electric company for service. Surface burners can be lit manually. *Oven control beeps Electronic control has detected a fault condition. Press CANCEL to clear the display and and displays any F stop beeping. Reprogram oven. If fault recurs, record fault number. Press CANCEL and call code error (ex.: F11) an authorized servicer for assistance. Oven light does not work. Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide. (2) Electrical power outage. Check house lights to be sure. Call your local electric company for service. Surface burners do not light. Surface control knob has not been completely turned to LITE. Push in and turn the surface control knob to LITE until burner ignites and then turn the surface control knob to the desired flame size. Burner ports are clogged. Clean burners. See "Cleaning the Burner Grates, Burner Caps and Burner Heads" under General Cleaning. Range power is disconnected from outlet. Be sure cord is securely plugged into the outlet. Electrical power outage. Be sure the gas supply to the range is turned "ON". Surface burner flame burns half way around. Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to clean ports or slots. Moisture is present after cleaning. Lightly fan the flame and allow the burner to operate until flame is full. Dry the burners thoroughly following instructions under General Cleaning. Surface burner flame Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue. is orange. Salt air in coastal areas. A slightly orange flame is unavoidable. Surface burner flame Surface burner valves are not adjusted properly. Refer to your LP conversion instructions is too high or too low. for guidance on how to adjust the valves. 33