Frigidaire FPCF3091LF Complete Owner's Guide (English) - Page 13

BEFORE SETTING SURFACE CONTROLS Cooktop power level display windows The cooktop power level display features provide a digital display for each of the heating positions located on the cooktop. Power levels are easily controlled and monitored using the window displays in combination with the corresponding control touch pads. Available power level settings The cooktop control will display heat levels ranging from Hi (Fig. 1) to Lo (Fig. 5) and OFF (Fig. 6). The settings between 9.5 (Fig. 2) and 3.0 (Fig. 3) decrease or increase in .5 increments. The settings between 3.0 (Fig. 3) and 1.2 (Fig. 4) are simmer settings which decrease or increase in increments of .2 for more precision at lower heat levels. Use the "Suggested power level settings table" provided later in this section to determine the correct setting for the type of food you are preparing. Power level settings-induction cooking zones only When setting either induction cooking zone to the highest level, the display will show Pb (Power Boost) power level for up to 10 minutes (See Fig. 7). After 10 minutes the cooking zone will automatically lower to the Hi setting. The Pb setting is only available immediately after activating a cooking zone and pressing the power level keypad. Hot surface window message (HE) After using a radiant element or induction cooking zone the cooktop may be very hot. After turning any of these elements OFF, the cooktop may remain HOT for some time. The corresponding HE (hot element - Fig. 8) message will remain ON and turn OFF once that element position on the cooktop has cooled sufficiently (Fig. 6). Lockout window message ( - - ) The (- -) message will appear whenever the lockout feature is active (See Fig. 9). Refer to the lockout instructions for more details. When the Sabbath Day feature is activated, the cooktop displays will show the cooktop lockout " - - " messages. IMPORTANT The induction cooktop will not operate when the oven is set for Sabbath mode. To set the Sabbath Day feature for the oven, see Setting Oven Controls section. Fig. 1 Fig. 3 Fig. 5 Fig. 2 Fig. 4 Fig. 6 Fig. 7 Fig. 8 Fig. 9 NOTE When setting the size for all 3 bridge elements to heat together, both the display windows for the left front and left rear elements will display the set power level & hot element message (for models with a bridge surface element feature only). 13