Frigidaire FPCF3091LF Complete Owner's Guide (English) - Page 8

BEFORE SETTING OVEN CONTROLS Oven vent location The oven vent is located under the left side of the control panel (See Fig. 1). When the oven is on, warm air passes through this vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block the oven vent. oven vent location Removing, replacing & arranging racks To remove - pull the rack forward until it stops. Lift up front of rack and slide out. To replace - fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place. Arranging - always arrange the oven racks when the oven is cool (prior to operating the oven). Fig. 1 CAUTION Always use oven mitts when using the oven. When using the appliance, oven racks and cooktop will become very hot which can cause burns. Types of oven racks flat handle oven rack 7 6 5 flat oven rack 4 3 half oven 2 rack 1 offset oven rack bottom oven rack The flat oven rack or flat handle oven rack (some models) may be used for most cooking needs. The half rack (some models) design comes with a removable section that allows for taller cooking utensils. The offset oven rack (some models) is designed to place the base of the rack about 1/2 of a rack position lower than normal. This rack design provides several additional possible positions between the standard positions. To maximize oven cooking space place the bottom oven rack (some models) in the lowest rack position for baking or roasting large cuts of meat. The Effortless™ Oven Rack (some models) is described later in this section. 8 Recommended rack positions Food type Broiling meats Cookies, cakes, pies, biscuits & muffins Frozen pies, angel food cake, yeast bread, casseroles Small cuts of meat or poultry Turkey, roast or ham Position See broil 4 or 5 2 or 3 1 or 2 1 or 2 IMPORTANT Only the Effortless™ Oven Rack should be used in oven rack position 2. Placing any other rack in rack position 2 will prevent the oven door from fully closing.