Frigidaire GHWW083WB1 Installation Instructions - Page 1
Frigidaire GHWW083WB1 Manual
View all Frigidaire GHWW083WB1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions READ BEFORE INSTALLING UNIT MSII MSIII Window Mounting (5,000~8,000 BTU) INSTALLATION WARNINGS AND CAUTION The unit is for window mounting only. Carefully read the installation manual before beginning. Follow each step as shown. Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only. Pay attention to danger and safety notices. To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed: Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To prevent injury or strain, use proper lifting and carrying techniques when moving unit. Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended period of time. Handle air conditioner with care. Make sure air conditioner does not fall during installation. NOTE: SAVE CARTON and these INSTALLATION INSTRUCTIONS for future reference. The carton is the best way to store unit during winter, or when not in use. DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED HERE. FOR SAFETY REASONS, THE TOP RAIL MUST BE SECURELY FASTENED WITH ALL FOUR (4) SCREWS. Some assembly is required. Please read these instructions carefully. Top Rail Hardware Qty. Mounting Hardware ( or Wooden windows) s) Qty. 7 2 2 1 weather stripping 5 (10"X3/4"X1/12") window sash seal foam 1 3/8 Screw 4 Top Rail 1 Drill (If pilot holes are needed) Before installing, the top rail must be assembled on the unit. A. Remove the air conditioner from the carton and place on a flat surface. B. Remove top rail from the rear of the packaging material as shown in Fig. A C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B D. Secure the top rail to the unit with the 3/8 Screws as shown in Fig. C Fig. A Packaging Top Rail 16120300A21175 1