Frigidaire GLTF2940FB Data Sheet - Page 5

Test Test 6: Test 7: Test 8: Check Test Correction 1. Is the water level above 4.5 inches? 2. Does water enter the washer continuously. 3. Remove power from washer. Does the water stop coming in? 4. Replace the pressure sensor switch. Did this correct the problem? 1. Is the loading door closed? 2. Disconnect the plug from J2 on the control board and check for continuity between the pins in the plug. 1. Remove power from the washer. Wait one minute. Can you open the door? Yes. Go to step (2). No. Go to step (4). Yes. Go to step (3). No. Replace the control board. No. Replace water valve assembly. Yes. Check wiring to valve assembly for shorts. If wiring is good, replace the control board. Yes. Problem solved. No. Replace the control board. No. Close the door. Yes. Go the step (2). Open. Check the door strike. If good, replace the door switch assembly. Closed. Replace the control board. Yes. Replace the control board. No. Replace the door switch assembly. Note: You may have to break the door strike to do this. Test 9: Test 10: 1. Remove the door lock assembly and measure the resistance of the PTC. 1. Disconnect the plug from the drive motor and measure the resistance pins 4 & 5 in the motor. Test 11: 1. Remove the belt from the motor and spin the motor pulley. Does the motor spin free? 2. Spin the tub pulley. Does the tub spin free? Test 12: 3. Disconnect the plug from the motor and measure the resistance of the windings (pin 1 to pin 2, pin 1 to pin 3, pin 2 to pin 3). All readings should be between 4 and 6 Ohms. 1. Remove the belt from the motor and spin the motor pulley. Does the motor spin free? 2. Spin the tub pulley. Does the tub spin free? 3. Disconnect the plug from the drive motor and measure the resistance between pins 4 & 5 in the motor. Shorted or open. Defective door lock assembly. Reads around 1500 Ohms. Defective control board. If the reading is between 105 & 130 Ohms, replace the speed control board. If the meter reads other than between 105 & 130 Ohms, replace the motor. No. Replace the motor. Yes. Go to step (3) No. Check the tub bearings. Yes. Go to step (3) If the readings are correct, replace the speed control board. If the readings are incorrect, replace the motor. No. Replace the motor. Yes. Go to step (3) No. Check the tub bearings. Yes. Go to step (3) If the meter reads other than between 105 & 130 Ohms, replace the motor. If the reading is between 105 & 130 Ohms, Go to step (4) Test 13: 4. Disconnect the plug from the motor and measure the resistance of the windings (pin 1 to pin 2, pin 1 to pin 3, pin 2 to pin 3). All readings should be between 4 and 6 Ohms. 1. Communication problem. Check the wiring between the control board and the speed control board. If the readings are correct, replace the speed control board. If the readings are incorrect, replace the motor. Wiring bad. Correct wiring problem. Wiring good. Replace the control board. If the problem is not corrected, replace the speed control board. Test 14: Test 15: 1. Check the resistance of the NTC. Is it around 50K ohms? 1. Have the power company check the frequency of the incoming power. If correct, replace the control board. No. Replace the water inlet valve assembly Yes. Replace the control board. 5 P/N 134408500