Fujitsu MAG3182LC Manual/User Guide - Page 103
Refer to of SCSI Logical Interface Specifications for further details.
View all Fujitsu MAG3182LC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Notes: 1. The user can arbitrarily specify the following parameters according to the system requirements: • ARRE • TB • PER 2. The user also can arbitrarily specify parameters other than the above. However, it is recommended to use the default setting in normal operations. (2) Disconnection/reconnection parameters (page code = 2) The following parameters are used to optimize the start timing of reconnection processing to transfer data on the SCSI bus at a read (READ or READ EXTENDED command) or write operation (WRITE, WRITE EXTENDED, or WRITE AND VERIFY command) of the disk. Refer to Chapter 2 of SCSI Logical Interface Specifications for further details. a. Disconnection/reconnection parameters (page code = 2) • Buffer full ratio • Buffer empty ratio Parameter Default value 20 (HEX) 20 (HEX) Notes: 1. In a system without the disconnection function, these parameters need not be specified. 2. Determine the parameter values in consideration of the following performance factors of the system: • Time required for reconnection processing • Average data transfer rate of the SCSI bus • Average amount of processing data specified with a command Refer to Chapter 2 of SCSI Logical Interface Specifications for how to obtain the rough calculation values for the parameter values to be set. It is recommended to evaluate the validity of the specified values by measuring performance in an operation status under the average system load requirements. 5 - 20 C141-E064-03EN