Fujitsu MAG3182LC Manual/User Guide - Page 9
Alert Items, Important Alert Messages
View all Fujitsu MAG3182LC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Important Alert Items Important Alert Messages The important alert messages in this manual are as follows: Task Mounting Installation A hazarous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. This alert signal also indicates that damages to the produt or other property, may occur if the user does not perform the procedure correctly. Alert message Heat An air flow with an adequate wind velocity must be maintained to deal with much heat generated from the MAF3364xx. Reference value: An air flow with a wind velocity of more than 0.5 m/s is required in an environment at 40°C, and an air flow with a wind velocity of more than 1.0m/s in an environment at 45°C (Center of DE cover 55°C). Data loss 1. The user must not change the setting of terminals not described in this section. Do not change setting status set at factory shipment. 2. Do not change the setting of terminals except following setting pins during the power is turned on. • Write protect: CN2 9-10 3. To short the setting terminal, use the short plug attached when the device is shipped from the factory. Damage 1. Check that system power is off before connecting or disconnecting cables. 2. Do not connect or disconnect cables when power is on. Data loss When the SEND DIAGNOSTIC command terminates with the CHECK CONDITION status, the INIT must collect the error information using the REQUEST SENSE command. The RECEIVE DIAGNOSTIC RESULTS command cannot read out the error information detected in the self-diagnostics. Damage Do not open the DE in the field because it is completely sealed. Data loss Save data stored on the disk drive before requesting repair. Fujitsu does not assume responsibility if data is destroyed during servicing or repair. Page 4-10 5-5 5-11 6-4 6-5 6-6 viii C141-E064-03EN