Fujitsu PDS-4222 User Manual - Page 11
Accessories, How To Use Accessories, Checking Accessories
View all Fujitsu PDS-4222 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English ACCESSORIES CHECKING ACCESSORIES One connector cover One remote control One strap (for remote control) Two AA batteries One user's manual (for remote control) Manual Four safety brackets Four screws (types A x 2, type B x 2) (screw A x 2, screw B x 2, for brackets that prevent the unit from falling over) Screw A (10 mm) Two ferrite cores (with wire clampers) Screw B (20 mm) Two cable clampers Three power cables HOW TO USE ACCESSORIES Cable clampers Use the supplied cable clampers to bind the display's signal or power cables. Use them as shown in the figure when mounting the display on the wall, using the wall-mounting unit, or hanging it from the ceiling using the hanging unit. When you run signal cables downwards When you run signal cables to the right Connector cover When you finish binding the cables using the cable clampers, you need to attach the connector cover to the display. To do this, use nippers to cut out a section of the connector cover such that the cables can be pulled out through that section. Then attach the cover to the display. When attaching the connector cover, make sure that the upper and lower projections on the cover fit properly into the corresponding sections on the display. Projections (to be fit into corresponding sections on the display) Information Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products. E-9