Fujitsu XG0448 Hardware Guide - Page 44

XG0448 Hardware Guide Chapter 2 Installation Prepare a Setup PC Log on using the terminal software. 1. Start up the terminal software by using the set up PC. 2. Set the setting conditions to the following; Item Start Bit Data Bit Parity Bit Stop Bit Synchronous System Communication Speed Flow Control Number of digits on screen Number of rows on screen Setting 1 8 n/a 1 Asynchronous Communication System (Start-Stop Communication System) 9600 None 80 (If other than 80 digits, set it through terminal command) 24 (If other than 24 rows, set it through terminal command) Please refer to the terminal software manual for instructions on setting conditions. 3. Press [Return] key or [Enter] key. Precautions The following message may appear When pressing the [Return] key or [Enter] key. In such case, the switch is processing another job, and waiting for such process to finish. Please wait for a moment until it finishes such process. Waiting for completion of the other operation... 4. Confirm "Login :" on screen. 5. Key in "admin" and press [Return] key or [Enter] key. 6. Confirm "Password:" on screen. 7. Key in password, then press the [Return] key or [Enter] key. Since password is not set at the initial state, simply press [Return] key or [Enter] key without keying in the password. If the password is already set, key in the password. Then press [Return] key or [Enter] key. 8. Confirm "#" is shown on screen If the key in the wrong password, "invalid password." will be displayed, then the "Login :" will be displayed again. Please repeat your process from item 5. 44 Connecting a Setup PC