Garmin Edge 1030 Edge External Battery Pack Instructions - Page 3
Device Information - mount
View all Garmin Edge 1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
2 Use the 2.5 mm hex key to remove the screw from the À handlebar connector . Á 3 Place a rubber pad around the handlebar: • If the handlebar diameter is 25.4 mm, use the thicker pad. • If the handlebar diameter is 31.8 mm, use the thinner pad. 4 Place the handlebar connector around the rubber pad. NOTE: You should align the contours on the rubber pad with the grooves on the inside of the handlebar connector. 5 Replace the screw, and use the 2.5 mm hex key to tighten the screw. NOTE: Garmin recommends tightening the screw so the mount is secure, with a maximum torque specification of 7 lbf-in. (0.8 N-m). You should check the tightness of the screw periodically. 6 Insert the battery pack into the bottom of the mount. The lever must be in the open position. The red mark  indicates the open position. Device Information Specifications Battery type Output capacity Battery operation time Charging temperature range Operating and storage temperature range Input Output Water rating Lithium-ion battery 3100 mAh at 5 V (15.5 Wh) Up to 24 hr. powering the Edge 1030 device From 0º to 45°C (from 32º to 113°F) From -20º to 60ºC (from -4º to 140ºF) 5 to 5.5 V, 2 A Electrical contacts: 5.07 V, up to 1 A USB port: 5.07 V, up to 2.4 A IEC 60529 IPX7* *The device withstands incidental exposure to water of up to 1 m for up to 30 min. For more information, go to www.garmin.com /waterrating. Limited Warranty The Garmin standard limited warranty applies to this accessory. For more information, go to www.garmin.com/support/warranty .html. 7 Snap the lever to the closed position to lock the battery pack into the mount. 8 Insert the Edge device into the top of the mount. The lever must be in the open position. The red mark à indicates the open position. 9 Snap the lever to the closed position to lock the Edge device into the mount. 10If necessary, use a USB cable to connect the Edge device to the output power USB-A port on the battery pack (Tips for Using the Battery Pack, page 2). Installation Instructions 3