Garmin Edge 800 Owner's Manual - Page 52

Heart Rate Monitor and GSC 10 Batteries, wARNING, CAUTION, Replacing the Heart Rate, Monitor Battery - battery replacement

Get Garmin Edge 800 PDF manuals and user guides View all Garmin Edge 800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Appendix 3. Plug the small end of the AC charger into the mini-USB port. To connect the device to your computer using the USB cable, see page 21. 4. Charge the device completely. A fully charged battery can run for up to 15 hours before it must be recharged. Replacing the Heart Rate Monitor Battery 1. Use a small Phillips screwdriver to remove the four screws on the back of the module. 2. Remove the cover and battery. Heart Rate Monitor and GSC 10 Batteries  warning Do not use a sharp object to remove user‑replaceable batteries.  caution Contact your local waste disposal department to properly recycle the batteries. Perchlorate Material - special handling may apply. See www.dtsc .ca.gov/hazardouswaste/perchlorate. 3. Wait 30 seconds. 4. Insert the new battery with the positive side facing up. Note: Do not damage or lose the O-ring gasket. 5. Replace the back cover and the four screws. After you replace the heart rate monitor battery, you must pair it with the device again. 48 Edge 800 Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
48
Edge 800 Owner’s Manual
Appendix
3. Plug the small end of the AC
charger into the mini-USB port.
To connect the device to your
computer using the USB cable, see
page 21
.
4. Charge the device completely.
A fully charged battery can run for up
to 15 hours before it must be recharged.
Heart Rate Monitor and
GSC 10 Batteries
wARNING
Do not use a sharp object to remove
user-replaceable batteries.
CAUTION
Contact your local waste disposal
department to properly recycle the
batteries. Perchlorate Material – special
handling may apply. See
www.dtsc
.ca.gov/hazardouswaste/perchlorate
.
Replacing the Heart Rate
Monitor Battery
1. Use a small Phillips screwdriver to
remove the four screws on the back
of the module.
2. Remove the cover and battery.
3. Wait 30 seconds.
4. Insert the new battery with the
positive side facing up.
NOTE
: Do not damage or lose the
O-ring gasket.
5. Replace the back cover and the four
screws.
After you replace the heart rate monitor
battery, you must pair it with the device
again.