Garmin Fishfinder 160C Owner's Manual - Page 12
Transducer Installation, To install the unit on the mounting bracket, To assemble the transducer - transducer mount
UPC - 753759047948
View all Garmin Fishfinder 160C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installing the Fishfinder 160C > Transducer Installation To install the unit on the mounting bracket: 1. Align the slot on the back of the unit with the long mounting knob and slide into place. It may be necessary to adjust the long knob to spread the bracket arms apart. (Turn counterclockwise to widen the bracket arms, clockwise to tighten.) 2. Adjust the unit angle and tighten the long mounting knob until snug. 3. Tilt the unit by loosening the long knob on the right side of the bracket assembly. 4. Rotate the entire bracket by twisting it left or right. (NOTE: You will hear clicks as you turn the bracket.) 5. Tighten all knobs when the viewing angle you want is obtained. Transducer Installation Once you've installed the Fishfinder 160C unit, you must install the transducer for it to function. The included transducer can be installed on the transom (see page 7) or on the trolling motor (see page 9). To assemble the transducer: 1. Insert the rubber washer and plastic spacer in the transducer at the same time. DO NOT lubricate the rubber washer. 2. Route the cable toward the back and slide the transducer into the mounting bracket. 3. Place a 5 mm flat washer on the 10-32 x 1.75" screw and insert the screw through the mounting bracket, spacer, and rubber washer. 4. Place the remaining 5 mm flat washer on the exposed end, and install the 10-32 lock nut finger tight. The transducer is tightened further after installation on the boat. Fishfinder 160C Owner's Manual