Garmin GA 30 Installation Instructions (Multilingual) - Page 3

GA 30 GPS Antenna Installation Instructions The Garmin® GA 30 GPS antenna provides GPS information to your compatible Garmin chartplotter. The GA 30 connects to compatible Garmin chartplotters using a BNC connector. Install the GA 30 antenna according to the following instructions. You need the appropriate fasteners, tools, and mounts listed in each section. These items are available at most marine dealers. See the Important Safety and Product Information guide in the compatible Garmin chartplotter box for product warnings and other important information. Caution: Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. When drilling or cutting, always check for clearance on the opposite side of the surface. Contact Garmin Contact Garmin Product Support if you have any questions while installing the GA 30. In the USA, go to www.garmin.com/support, or contact Garmin USA by phone at (913) 397.8200 or (800) 800.1020. In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000. In Europe, go to www.garmin.com/support and click Contact Support for in-country support information, or contact Garmin (Europe) Ltd. by phone at +44 (0) 870.8501241. Product Registration Help us better support you by completing our online registration today. Go to http://my.garmin .com. Keep the original sales receipt, or a photocopy, in a safe place. For future reference, write the serial number assigned to your GA 30 antenna in the space provided. It is located on a sticker on the back of the unit. Serial number Packing List and Tools Needed Before installing your unit, confirm that your package includes the following items. If any parts are missing, contact your Garmin dealer immediately. Standard Package • GA 30 antenna • Antenna cable • Surface-mount bracket • Pole-mount bracket • Under-deck mount bracket • Mounting hardware (screws and adhesive pads) • Installation instructions Tools Needed • Drill and drill bits • Hole saw, 1 in. (25 mm) (surface-mount cable hole) • Screwdriver (surface-mount screws) • Center punch and hammer (to mark surface-mount pilot holes) • Countersink bit (when mounting on fiberglass) • Marine sealant (for certain mounting options) GA 30 GPS Antenna Installation Instructions