Garmin GA 30 Installation Instructions (Multilingual) - Page 5

8. Secure the antenna to the mounting bracket with the included M3 set screw ➌. 9. Route the cable away from sources of electronic interference, and connect it to your GPS device using the BNC connector. Pole Mounting the GA 30 Antenna With the pole-mount adapter attached to the GA 30 antenna, you can install the antenna on a standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch-not included). You can run the cable through the pole or outside the pole. To mount the GA 30 with the cable run outside the pole: 1. Route the cable through the pole-mount adapter, and place the cable in the vertical slot along the base of the pole-mount adapter. 2. Thread the pole-mount adapter onto a standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch-not included). Do not overtighten the adapter. 3. Connect the cable to the GA 30 antenna. 4. Place the GA 30 antenna on the pole-mount adapter ➊ and twist the antenna clockwise to lock it in place ➋. 5. Secure the antenna to the adapter with the ➊ included M3 set screw ➌. 6. (Optional) With the GA 30 installed on the pole mount, fill the remaining gap in the vertical cable slot with a marine sealant. ➋ ➌ GA 30 antenna 7. Attach the marine pole mount to the boat if it is not already attached. 8. Route the cable away from sources of Pole-mount electronic interference, and connect it to your adapter GPS device using the BNC connector. To mount the GA 30 with the cable run through the pole: Vertical cable slot 1. Position a standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch-not included) in the preferred location, and mark the approximate center of the pole. 2. Drill a 3/4 in. (19 mm) hole for the cable to pass through. 3. Fasten the pole marine mount to the boat. 4. Thread the pole-mount adapter onto the pole. Do not overtighten the adapter. 5. Route the cable through the pole and connect it to the GA 30 antenna. 6. Place the GA 30 antenna on the pole-mount adapter ➊ and twist the antenna clockwise to lock it in place ➋. 7. Secure the antenna to the adapter with the included M3 set screw ➌. 8. (Optional) With the GA 30 installed on the pole mount, fill the vertical cable slot with a marine sealant. 9. Route the cable away from sources of electronic interference, and connect it to your GPS device using the BNC connector. GA 30 GPS Antenna Installation Instructions