Garmin GPS 17HVS 2006/2010/GPS 17 Installation - Page 7

To attach the enclosed pole mount to the GPS 17, To mount the GPS 17 with cable outside mount,

Get Garmin GPS 17HVS - Receiver Module PDF manuals and user guides
UPC - 753759052546
View all Garmin GPS 17HVS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

To attach the enclosed pole mount to the GPS 17: 1. Thread the cable though the pole mount. 2. Align the tab on the mount to the notch on the GPS 17. 3. Use the enclosed screws to secure the mount to the base. Attaching the Pole Mount to the GPS 17 Align notch INSTALLATION INSTRUCTIONS To mount the GPS 17 with cable outside mount: 1. Place the cable in the vertical slot along the side of the base of the unit. 2. Screw the GPS 17 onto the mount. DO NOT overtighten the head. It is possible to over tighten the unit and cut the cable. 3. With the GPS 17 and mount installed, fill the remaining gap in the cable exit with a marine sealant. 4. Route the cable away from sources of electronic interference. To mount the GPS 17 with cable through mount: 1. Position the mount in the desired location and mark the approximate center of the mount. 2. Drill a hole large enough for the cable to pass through. 3. Slide the cable through the mount and screw the GPS 17 onto the mount. 4. Fasten the mount to the boat. 5. Route the cable away from sources of electronic interference. Attaching the GPS 17 to a Pole Mount Cable run externally GPSMAP 2006C/2010C & GPS 17 Cable run internally 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
7
I
NSTALLATION
I
NSTRUCTIONS
GPSMAP 2006C/2010C & GPS 17
To attach the enclosed pole mount to the GPS 17:
1.
Thread the cable though the pole mount.
2.
Align the tab on the mount to the notch on the GPS 17.
3.
Use the enclosed screws to secure the mount to the base.
Attaching the Pole Mount to the GPS 17
Align notch
To mount the GPS 17 with cable outside mount:
1.
Place the cable in the vertical slot along the side of the base of
the unit.
2.
Screw the GPS 17 onto the mount. DO NOT overtighten the
head. It is possible to over tighten the unit and cut the cable.
3.
With the GPS 17 and mount installed, fill the remaining gap in
the cable exit with a marine sealant.
4.
Route the cable away from sources of electronic interference.
To mount the GPS 17 with cable through mount:
1.
Position the mount in the desired location and mark the
approximate center of the mount.
2.
Drill a hole large enough for the cable to pass through.
3.
Slide the cable through the mount and screw the GPS 17 onto
the mount.
4.
Fasten the mount to the boat.
5.
Route the cable away from sources of electronic interference.
Cable run internally
Cable run externally
Attaching the GPS 17 to a Pole Mount