Garmin GPS 24xd Receiver and Antenna Installation Instructions - Page 1
Garmin GPS 24xd Receiver and Antenna Manual
View all Garmin GPS 24xd Receiver and Antenna manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
GPS 24XD NMEA 2000® INSTALLATION INSTRUCTIONS Important Safety Information CAUTION To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. NOTICE When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel. For the best performance and to avoid damage to your boat, read all installation instructions before proceeding. Install the device per these instructions. Use the appropriate fasteners, tools, and mounts listed, which are available at most marine dealers. The Garmin® GPS 24xd NMEA 2000 high-sensitivity GPS antenna provides position information to your existing NMEA 2000 network. If your boat does not have a NMEA 2000 network, you will need to install one. For more information, go to garmin.com. Tools Needed • Drill • 3.2 mm (1/8 in.) drill bit • 19 mm (3/4 in.) drill bit for a pole-mount cable-hole • 25 mm (1 in.) hole saw for a surface-mount cable-hole • Countersink bit for mounting on fiberglass • Screws for under-deck mounting • Screwdriver, appropriate for the screw type • Marine sealant (optional) • Additional NMEA 2000 network components as needed September 2023 TA-2020/6796 GUID-28CE8C25-CFD8-4C12-B6D0-AD9CDF4D5084 v6