Garmin GSD 21 Installation Instructions - Page 6

Serial Wiring for the Garmin GSD 21 to a Single GPSMAP 3005C/3205 - sounder

Get Garmin GSD 21 - GPS Receiver Remote Sonar Sensor PDF manuals and user guides
UPC - 753759052232
View all Garmin GSD 21 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

INSTALLATION INSTRUCTIONS 4 Serial Wiring for the Garmin GSD 21 to a Single GPSMAP 3005C/3205 FUSE 2 A WIRE COLOR RED BLACK ORANGE WHITE/BLUE WHITE/BROWN WIRE COLOR RED FUSE 2 A BLACK ORANGE WHITE/BLUE WHITE/BROWN GARMIN GSD 21 SOUNDER MODULE TO TRANSDUCER BATTERY 10-35 VOLTS DC Notes: 1. You can extend the serial/power wiring of the GSD 21 power/data cable up to 100 ft (30 m) total length. Use the CANet Extension Cable or 22 AWG, 4-conductor shielded cable for data connections and 18 AWG for power. 2. Ground the drain wire at the display unit. Do not ground the drain wire on the sonar unit. 3. Refer to the chartplotter's specific Installation Instructions for wiring the GPS 17 sensor and other devices. 4. When crimping the 3-wire connector, use a standard pair of pliers and make sure the button is fully depressed into the connector. GSD 21 Sonar Module

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
4
GSD 21 Sonar Module
I
NSTALLATION
I
NSTRUCTIONS
WIRE
COLOR
GARMIN GSD 21
SOUNDER MODULE
BLACK
ORANGE
RED
WHITE/BLUE
BLACK
RED
WHITE/BLUE
WHITE/BROWN
WHITE/BROWN
WIRE
COLOR
2 A
FUSE
ORANGE
2 A
FUSE
TO
TRANSDUCER
BATTERY
10-35 VOLTS DC
Serial Wiring for the Garmin GSD 21 to a Single GPSMAP 3005C/3205
Notes:
1. You can extend the serial/power wiring of the GSD 21 power/data cable up to 100 ft (30 m) total length. Use the CANet Extension Cable or
22 AWG, 4-conductor shielded cable for data connections and 18 AWG for power.
2. Ground the drain wire at the display unit. Do not ground the drain wire on the sonar unit.
3. Refer to the chartplotter’s specific Installation Instructions for wiring the GPS 17 sensor and other devices.
4. When crimping the 3-wire connector, use a standard pair of pliers and make sure the button is fully depressed into the connector.