Garmin GSD 24 Installation Instructions - Page 5

Blink Codes When the sounder is installed, it turns on when the chartplotter is turned on. The two-color (green and red) LED on the sounder indicates the current operational status of the device. LED Color Green Red Red/Green Red Red Blink Speed Slow Slow Fast Very Fast Solid Status Sounder is connected to a chartplotter and is operating properly. You should see sonar data on the chartplotter Sounder is turned on, but is not connected to a chartplotter, is waiting to connect to a chartplotter, or has a malfunctioning XID. If the sounder is connected to the chartplotter and this code persists, check the wiring and connections. Sounder is in test mode. System alarm. The chartplotter displays a message indicating the type of failure. When the alarm condition is fixed, the sounder must be completely disconnected from and reconnected to its power source to clear the alarm. Sounder has a hardware failure. Contact Garmin Product Support for assistance. Specifications Size GSD 24: L × W × H: 8 × 11.2 × 3.2 in. (204 × 283 × 81 mm) GSD 26: L × W × H: 10.8 × 14.7 × 3.9 in. (274 × 373 × 100 mm) Weight GSD 24: 5.27 lb. (2.39 kg) GSD 26: 11.37 lb. (5.16 kg) Case Material GSD 24: Fully gasketed, aluminum and steel housing, waterproof to IEC 529-IPx7. GSD 26: Fully gasketed, aluminum and steel housing with plastic access panel, waterproof to IEC 529-IPx7. Temperature From 5°F to 158°F (from -15°C to 70°C) Range Power Input 10-35 V Power Usage GSD 24: 40 W maximum GSD 26: 100 W maximum Fuse GSD 24: 7.5 A GSD 26: 10 A Compass Safe GSD 24: 15.75 in. (40 cm) Distance GSD 26: 23.6 in. (60 cm) Sounder Power GSD 24: 25-2,000 W rms* GSD 26: 25-3,000 W rms* *dependent upon transducer rating and depth Frequency GSD 24: 50/200 kHz GSD 26: 25-210 kHz (dependent upon transducer) Depth GSD 24: 5,000 ft. (1,512 m)** GSD 26: 10,000 ft. (3,048 m)** **maximum depth, dependent upon transducer, water salinity, bottom type, and other water conditions Data Output Garmin Marine Network Declaration of Conformity Hereby, Garmin International, Inc. declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/ EEC. The Declaration of Conformity may be obtained at www.garmin.com/compliance. FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet that is on a different circuit from the GPS unit. • Consult the dealer or an experienced radio/TV technician for help. Industry Canada Compliance Category I radiocommunication devices comply with Industry Canada Standard RSS-210. Category II radiocommunication devices comply with Industry Canada Standard RSS-310. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Limited Warranty This Garmin product is warranted to be free from defects in materials or workmanship for one year from the date of purchase. Within this period, Garmin will, at its sole option, repair or replace any components that fail in normal use. Such repairs or replacement will be made at no charge to the customer for parts or labor, provided that the customer shall be responsible for any transportation cost. This warranty does not apply to: (i) cosmetic damage, such as scratches, nicks and dents; (ii) consumable parts, such as batteries, unless product damage has occurred due to a defect in materials or workmanship; (iii) damage caused by accident, abuse, misuse, water, flood, fire, or other acts of nature or external causes; (iv) damage caused by service performed by anyone who is not an authorized service provider of Garmin; or (v) damage to a product that has been modified or altered without the written permission of Garmin. In addition, Garmin reserves the right to refuse warranty claims against products or services that are obtained and/or used in contravention of the laws of any country. This product is intended to be used only as a travel aid and must not be used for any purpose requiring precise measurement of direction, distance, location or topography. Garmin makes no warranty as to the accuracy or completeness of map data in this product. THE WARRANTIES AND REMEDIES CONTAINED HEREIN ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES EXPRESS, IMPLIED, OR STATUTORY, INCLUDING ANY LIABILITY ARISING UNDER ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, STATUTORY OR OTHERWISE. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, WHICH MAY VARY FROM STATE TO STATE. IN NO EVENT SHALL GARMIN BE LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, INCLUDING, WITHOUT LIMITATION, DAMAGES FOR ANY TRAFFIC FINES OR CITATIONS, WHETHER RESULTING FROM THE USE, MISUSE OR INABILITY TO USE THE PRODUCT OR FROM DEFECTS IN THE PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU. Garmin retains the exclusive right to repair or replace (with a new or newlyoverhauled replacement product) the device or software or offer a full refund of the purchase price at its sole discretion. SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY. To obtain warranty service, contact your local Garmin authorized dealer or call Garmin Product Support for shipping instructions and an RMA tracking number. Securely pack the device and a copy of the original sales receipt, which is required as the proof of purchase for warranty repairs. Write the tracking number clearly on the outside of the package. Send the device, freight charges prepaid, to any Garmin warranty service station. Online Auction Purchases: Products purchased through online auctions are not eligible for warranty coverage. Online auction confirmations are not accepted for warranty verification. To obtain warranty service, an original or copy of the sales receipt from the original retailer is required. Garmin will not replace missing components from any package purchased through an online auction. GSD 24/26 Installation Instructions 5