Garmin LiveScope Plus LVS34-IF Transducer Installation Instructions - Page 2
Installing the Transducer on an Ice Fishing Pole, CAUTION
View all Garmin LiveScope Plus LVS34-IF Transducer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Installing the Transducer on an Ice Fishing Pole CAUTION Keep the transducer cable secure. Failure to do so could create a trip and fall hazard, which could result in personal injury. NOTICE You can use electrical tape or cable ties to secure the transducer cable. If you use cable ties, do not over-tighten them. Over-tightening cable ties can damage the cable and cause transducer failure. NOTE: If you do not plan to change the viewing mode of the transducer often or prefer a lower-profile installation without the adjustment knob, you can use the included low-profile hardware (Installing the Transducer Using Low-Profile Mounting Hardware, page 3). TIP: The top of the transducer must be below the bottom of the ice for best performance. To install the transducer on an ice fishing pole (not included), you can use the included hardware and hex wrench. 1 If the pole is equal to or less than 25 mm (1 in.) in diameter, wrap the rubber liner around the pole at the mounting location. 2 Place the halves of the shaft-mount bracket around the pole or pole with rubber liner at the mounting location. 3 Insert the screws into the shaft mount bracket, and secure them using the hex wrench. 4 Place the transducer against the shaft-mount bracket, and secure it using the neoprene washer and knob . 5 Secure the transducer cable to the pole or other secure location, and route the cable to the GLS™ 10 sonar module. 2