Garmin LiveScope Plus LVS34-IF Transducer Installation Instructions - Page 3

Installing the Transducer Using Low-Profile Mounting Hardware, Installing the Transducer on an Ice

Get Garmin LiveScope Plus LVS34-IF Transducer PDF manuals and user guides View all Garmin LiveScope Plus LVS34-IF Transducer manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

6 Connect the transducer cable to the XDCR port on the GLS 10 sonar module. TIP: To reduce electromagnetic interference, snap the ferrite bead (if included) onto the transducer cable near the connector to the GLS 10 sonar module. 7 Position the transducer for the desired view. TIP: Turn the transducer one click to change the orientation from down to forward . Installing the Transducer Using Low-Profile Mounting Hardware If you do not plan to change the viewing mode of the transducer often, or prefer a lower-profile installation without the adjustment knob, you can use the included low-profile hardware. 1 Install the mounting bracket but do not use the included adjustment knob (Installing the Transducer on an Ice Fishing Pole, page 2). 2 Instead of using the knob, use the low-profile screw and metal washer to secure the transducer to the mounting bracket. 3 Adjust the view of the transducer and tighten the low-profile screw using the included hex wrench. 3

  • 1
  • 2
  • 3
  • 4
6
Connect the transducer cable to the XDCR port on the GLS 10 sonar module.
TIP:
To reduce electromagnetic interference, snap the ferrite bead (if included) onto the transducer cable
near the connector to the GLS 10 sonar module.
7
Position the transducer for the desired view.
TIP:
Turn the transducer one click to change the orientation from down
to forward
.
Installing the Transducer Using Low-Profile Mounting Hardware
If you do not plan to change the viewing mode of the transducer often, or prefer a lower-profile installation
without the adjustment knob, you can use the included low-profile hardware.
1
Install the mounting bracket but do not use the included adjustment knob (
Installing the Transducer on an Ice
Fishing Pole
, page 2
).
2
Instead of using the knob, use the low-profile screw
and metal washer
to secure the transducer
to
the mounting bracket.
3
Adjust the view of the transducer and tighten the low-profile screw using the included hex wrench.
3