Garmin PRO Control 2 Remote Launch System Owner s Manual PDF - Page 11
Updating the Receiver Software, Downloading a Custom Sound, Resetting the Receiver to Factory
View all Garmin PRO Control 2 Remote Launch System manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
PRO Control 2 Receiver Components Security screws À Battery connector Á Receiver housing  Screws for battery plate à Battery plate Ä Battery Å Replacing the PRO Control 2 Receiver Battery Before you replace the battery, you must remove all dirt, water, and debris from the device. You can purchase a replacement battery at (http://buy.garmin.com). You should use only an official Garmin replacement part. 1 Remove the eight security screws from the back of the device. 2 Lift up the receiver housing. 3 Press down firmly on the release tab for the battery connector, and disconnect the battery connector from the device. 4 Remove the screws from the battery plate, and remove the plate. 5 Remove the old battery, noting the orientation of the battery. The battery fits tightly. You may pry the battery out of the back plate using a non-sharp, non-metal object. 6 Install the new battery with the label side up, using the same orientation as the old battery. 7 Replace the battery plate, and replace its screws. 8 Verify that the gasket is not damaged and is completely seated in the groove in the receiver housing. 9 Connect the battery connector to the device. 10Hold the bottom plate and the device firmly together, and replace all eight security screws without tightening. 11Verify the bottom plate and the device are aligned with no gaps. 12Tighten the screws evenly. Updating the Receiver Software 1 Connect your device to a computer using the USB cable (Connecting the Device to Your Computer, page 7). 2 Go to garmin.com/express. 3 Follow the on-screen instructions. Connecting the Device to Your Computer NOTICE To prevent corrosion, thoroughly dry the USB port, the weather cap, and the surrounding area before charging or connecting to a computer. 1 Pull up the weather cap from the USB port on the device. 2 Plug the small end of the USB cable into the USB port on the device. 3 Plug the large end of the USB cable into a computer USB port. Your device appears as a removable drive in My Computer on Windows® computers and as a mounted volume on Mac® computers. Downloading a Custom Sound Before you can download a custom sound from your computer to your receiver, your sound file must be in the proper audio format (Custom Sound File Requirements, page 7). 1 Name the custom sound file to associate it with a color. Color Filename Blue (left) 1.wav Black (middle) 2.wav Red (right) 3.wav 2 Connect the receiver to your computer (Connecting the Device to Your Computer, page 7). Depending on your computer operating system, the device appears as either a portable device, a removable drive, or a removable volume. 3 On your computer, browse to the custom sound file location. 4 Copy the custom sound file to the GARMIN/WAV folder on your receiver. When you select the receiver sound (Selecting the PRO Control 2 Receiver Sound, page 3), the custom sound plays. Custom Sound File Requirements Audio file format Channels Resolution Sample rate Maximum duration Waveform (.wav) Mono or stereo 16-bit 32 kHz 50 sec. for mono for all three sounds 25 sec. for stereo for all three sounds Resetting the Receiver to Factory Defaults A factory reset unpairs the receiver, erases sounds stored on the receiver, and restores the original factory sounds. 1 Connect the receiver to the computer or charger (Connecting the Device to Your Computer, page 7). 2 Hold the power key for 15 seconds until the LED is solid yellow. Factory reset is complete when the LED turns off. Device Maintenance 7